Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 793

Usage Information Related Command This feature groups two LAGs to work in tandem as a supergroup. For example, if one LAG goes down, the other LAG is taken down automatically, providing an alternate path to reroute traffic, avoiding oversubscription on the other LAG. You can use both static and dynamic (LACP) LAGs to configure failover groups. For more information, refer to the "Port Channel" chapter in the Dell Networking OS Configuration Guide. group - groups two LAGs in a supergroup ("fate-sharing group"). show interfaces port-channel - displays information on configured Port Channel groups. show config Display the current configuration of the selected LAG. C9000 Series Syntax show config Command Modes INTERFACE PORTCHANNEL Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 7.6.1.0 7.5.1.0 6.2.1.0 Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Example Dell(conf-if-po-1)# show config ! interface Port-channel 1 no ip address shutdown Dell(conf-if-po-1)# show interfaces port-channel Display information on configured Port Channel groups. C9000 Series Syntax Parameters show interfaces port-channel [channel-number] [brief] channel-number For a Port Channel interface, enter the keyword port-channel then a number. The range is from 1 to 128. Interfaces 793