Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 387

permit bandwidth Specify link bandwidth extended-community attribute as the matching criteria to permit incoming or outgoing traffic. Syntax permit bandwidth To disable this setting, enter the no permit bandwidth command. Parameters bandwidth Enter the keyword bandwidth to specify extended-community attribute as the matching criteria for permitting traffic. The range is from 0 to 102400. Defaults N/A Command Modes EXTENDED COMMUNITY LIST Command History Version 9.9(0.0) Description Introduced on the C9010. 9.8(0.0) Introduced on the S3048-ON and S4048-ON. 9.7(0.0) Introduced on the S-Series. Related Commands deny bandwidth - link bandwidth extended-community attribute as the matching criteria to deny incoming or outgoing traffic.. redistribute Redistribute routes into BGP. C9000 Series Syntax Parameters redistribute {connected | static} [route-map map-name] To disable redistribution, use the no redistribution {connected | static} command. connected static route-map mapname Enter the keyword connected to redistribute routes from physically connected interfaces. Enter the keyword static to redistribute manually configured routes. These routes are treated as incomplete routes. (OPTIONAL) Enter the keyword route-map then the name of an established route map. Only the following ROUTE-MAP mode commands are supported: ● match ip address ● set community ● set local-preference ● set metric ● set next-hop ● set origin ● set weight If the route map is not configured, the default is deny (to drop all routes). Defaults Not configured. Command Modes ROUTER BGP Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. Border Gateway Protocol 387