Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 103

Usage Information Version 7.5.1.0 E-Series Description Introduced on the C-Series. Original command. CAUTION: Use this command only when you are working directly with a technical support representative to troubleshoot a problem. Do not use this command unless a technical support representative instructs you to do so. show cpu-traffic-stats View CPU traffic statistics. C9000 Series Syntax Parameters show cpu-traffic-stats [cp | rp | linecard {slot-id | pe ] number all cp rp pe Specify an interface number. The number of interfaces range from 1 to 1568. Enter the keyword all to display traffic statistics on all the interfaces. Enter the keyword cp to display traffic statistics on the Control Processor CPU. Enter the keyword rp to display traffic statistics on the Route Processor CPU. Enter the keyword pe to display traffic statistics on the Port Extender. Defaults Display CPU traffic statistics for all switch CPUs (Control Processor and Route Processor). Command Modes EXEC Example Dell#show cpu-traffic-stats Command History Usage Information This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.12.0 8.3.11.1 7.6.1.0 7.5.1.0 6.2.1.1 Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the S4810. Introduced on the Z9000. Introduced on the S-Series. Introduced on the C-Series Introduced on the E-Series. Traffic statistics are sorted on a per-interface basis; the interface receiving the most traffic is displayed first. All CPU and port information is displayed unless a specific port or CPU is specified. Traffic information is displayed for router ports only; not for management interfaces. The traffic statistics are collected only after the debug cpu-traffic-stats command is executed; not from the system bootup. NOTE: After debugging is complete, use the no debug cpu-traffic-stats command to shut off traffic statistics collection. Control and Monitoring 103