Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 1176

ip ospf cost Change the cost associated with the OSPF traffic on an interface. C9000 Series Syntax Parameters ip ospf cost cost To return to default value, use the no ip ospf cost command. cost Enter a number as the cost. The range is from 1 to 65535. Defaults The default cost is based on the reference bandwidth. Command Modes INTERFACE Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 7.6.1.0 7.5.1.0 6.1.1.1 Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Usage Information Related Commands If this command is not configured, cost is based on the auto-cost command. When you configure OSPF over multiple vendors, to ensure that all routers use the same cost, use the ip ospf cost command. Otherwise, OSPF routes improperly. auto-cost - controls how the OSPF interface cost is calculated. ip ospf dead-interval Set the time interval since the last hello-packet was received from a router. After the interval elapses, the neighboring routers declare the router dead. C9000 Series Syntax Parameters ip ospf dead-interval seconds To return to the default values, use the no ip ospf dead-interval command. seconds Enter the number of seconds for the interval. The range is from 1 to 65535. The default is 40 seconds. Defaults 40 seconds Command Modes INTERFACE 1176 Open Shortest Path First (OSPFv2 and OSPFv3)