Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 782

the speed command. When you set the speed to 10 or 100 Mbps, you can also use the duplex command. If you use an active optical cable (AOC), you can convert the QSFP+ port to a 10 Gigabit SFP+ port or 1 Gigabit SFP port. You can use the speed command to enable the required speed. speed (Management interface) Set the speed for the Management interface. C9000 Series Syntax Parameters speed {10 | 100 | auto} To return to the default setting, use the no speed {10 | 100} command. 10 100 auto Enter the keyword 10 to set the interface's speed to 10 Mb/s. Enter the keyword 100 to set the interface's speed to 10/100 Mb/s. Enter the keyword auto to set the interface to auto-negotiate its speed. Defaults auto Command Modes INTERFACE Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.11.1 8.1.1.0 7.5.1.0 6.2.1.0 Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S55, S60, and S4810 Introduced on the E-Series ExaScale. Introduced on the C-Series. Introduced on the E-Series. Usage Information Related Commands This command is found on the Management interface only. ● interface ManagementEthernet - configures the Management port on the system (either the Primary or Standby RPM). ● management route - configures a static route that points to the Management interface or a forwarding router. 782 Interfaces