Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 74

enable optic-info-update interval Enable polling intervals of optical information updates for simple network management protocol (SNMP). C9000 Series Syntax Parameters enable optical-info-update interval seconds To disable optical power information updates, use the no enable optical-info-update interval command. interval seconds Enter the keyword interval then the polling interval in seconds. The range is from 120 to 6000 seconds. The default is 300 seconds (5 minutes). Defaults Disabled Command Modes CONFIGURATION Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.4 8.3.10.0 Introduced on the C9010. Introduced on the Z9500. Replacement command for the S4820T. Replaces the enable xfp-powerupdates command. Replacement command for the Z9000. Replaces the enable xfp-powerupdates command Replacement command for the S4810 only. Replaces the enable xfp-powerupdates command. Usage Information To enable polling and to configure the polling frequency, use this command. end Return to EXEC Privilege mode from other command modes (for example, CONFIGURATION or ROUTER OSPF modes). C9000 Series Syntax end Command Modes ● CONFIGURATION ● SPANNING TREE ● MULTIPLE SPANNING TREE ● LINE ● INTERFACE ● TRACE-LIST ● VRRP ● ACCESS-LIST ● PREFIX-LIST ● AS-PATH ACL 74 Control and Monitoring