Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 704

Field RPM Failover Record Last Data Sync Record Description ● the status of auto booting the RPM (the redundancy disable-autoreboot command) ● the parameter for auto failover limit control (the redundancy autofailover-limit command) Displays the following information: ● RPM failover counter (to reset the counter, use the redundancy resetcounter command) ● the time and date of the last RPM failover ● the reason for the last RPM failover Displays the data sync information and the timestamp for the data sync: ● Start-up Config is the contents of the startup-config file. ● Line Card Config is the line card types configured and interfaces on those line cards. ● Runtime Event Log is the contents of the Event log. ● Running Config is the current running-config. This field only appears when you enter the command from the Primary RPM. Example Example: show redundancy pe pe-id Dell# show redundancy -- RPM Status -- RPM Slot ID: 1 RPM Redundancy Role: Primary RPM State: Active RPM SW Version: 7.5.1.0 Link to Peer: Up -- PEER RPM Status -- RPM State: Standby RPM SW Version: 7.5.1.0 -- RPM Redundancy Configuration -- Primary RPM: rpm0 Auto Data Sync: Full Failover Type: Hot Failover Auto reboot RPM: Enabled Auto failover limit: 3 times in 60 minutes -- RPM Failover Record -- Failover Count: 1 Last failover timestamp: Jul 13 2007 21:25:32 Last failover Reason: User request -- Last Data Block Sync Record: -- Line Card Config: succeeded Jul 13 2007 21:28:53 Start-up Config: succeeded Jul 13 2007 21:28:53 SFM Config State: succeeded Jul 13 2007 21:28:53 Runtime Event Log: succeeded Jul 13 2007 21:28:53 Running Config: succeeded Jul 13 2007 21:28:53 Dell# Dell#show redundancy pe 0 -- pe Status 704 High Availability (HA)