Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 541

dcb-policy output Apply the output policy with the ETS configuration to an egress interface. C9000 Series Syntax Parameters dcb-policy output policy-name To delete the output policy, use the no dcb-policy output command. policy-name Enter the output policy name. Defaults none Command Modes INTERFACE Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.6(0.0) 9.0.2.0 8.3.19.0 8.3.12.0 8.3.16.0 Introduced on the C9010. Removed from the S-series. Replaced by the dcb-map commands. Introduced on the S6000. Introduced on the S4820T. Introduced on the S4810. Introduced on the MXL 10/40GbE Switch IO Module. Usage Information Related Commands When you apply an ETS output policy to on interface, ETS-configured scheduling and bandwidth allocation take precedence over any configured settings in QoS output policies. When you disable DCB, ETS is disabled by default. When you enable DCB, ETS is enabled for all interfaces that have the default ETS configuration applied (all dot1p priorities in the same group with equal bandwidth allocation). dcb-map- to configure PFC and ETS on Ethernet ports that support converged Ethernet traffic. clear ets counters Clear all ETS TLV counters on an interface. C9000 Series Syntax Parameters clear ets counters port-type slot/port port-type Enter the keywords port-type then the slot/port information. Defaults none Command Modes EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Data Center Bridging (DCB) 541