Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 806

Usage Information Related Commands The interface must be enabled to run the test or an error message is generated: DellEMC# tdr-cable-test tengigabitethernet 11/1 % Error: Interface is disabled Te 11/1. Syslog messages are generated when the link flaps during TDR tests. In a dual homing setup, you can use this command only from the primary VLT peer. ● show tdr - display the results of the TDR test. show tdr Display the TDR test results. Syntax Parameters show tdr interface interface Enter the keyword TenGigabitEthernet , peGigE or peTenGigE then the slot/port information for the 100/1000 Ethernet interface. Defaults None Command Modes EXEC Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide. Version Description 9.13.0.1P1 9.10(0.1) 9.10(0.0) 9.9(0.0) 9.8(2.0) 9.8(0.0P5) 9.8(0.0P2) 9.7.0.0 8.3.19.0 8.3.11.1 8.3.7.0 8.2.1.0 7.7.1.0 7.6.1.0 6.1.1.0 Introduced peTenGigE interface support on the C9010. Introduced on the S4048T-ON. Introduced on the S3148. Introduced on the C9010. Introduced on the S3100 series. Introduced on the S4048-ON. Introduced on the S3048-ON. Introduced on the S5000. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the E-Series. Introduced on the S-Series. Introduced on the C-Series. Introduced. Usage Information If the TDR test has not been run, an error message is generated: %Error: Please run the TDR test first The following describes the TDR test status. Status Definition OK Status: Terminated TDR test is complete, no fault is detected on the cable, and the test is terminated. 806 Interfaces