Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 927

Version 8.3.11.1 8.3.7.0 8.1.1.0 7.6.1.0 7.5.1.0 6.1.1.0 Description Introduced on the Z9000. Introduced on the S4810. Introduced on the E-Series ExaScale. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. ip unreachables Enable the generation of internet control message protocol (ICMP) unreachable messages. C9000 Series Syntax ip unreachables To disable the generation of ICMP messages, use the no ip unreachables command. Defaults Disabled. Command Modes INTERFACE Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 8.1.1.0 7.6.1.0 7.5.1.0 6.1.1.0 Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the E-Series ExaScale. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. ipv4 unicast-host-route Enable the storage of IPv4 route prefixes in the L3 host table. C9000 Series Syntax Defaults [no] ipv4 unicast-host-route Disabled; by default, all IPv4 route prefixes are stored installed only in the Longest Prefix Match (LPM) table. IPv4 Routing 927