Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 849

Parameters connected rip static metric metricvalue metric-type {external | internal} level-1 level-1-2 level-2 route-map mapname Enter the keyword connected to redistribute active routes into IS-IS. Enter the keyword rip to redistribute RIP routes into IS-IS. Enter the keyword static to redistribute user-configured routes into IS-IS. (OPTIONAL) Assign a value to the redistributed route. The range is from 0 to 16777215. The default is 0. Use a value that is consistent with the destination protocol. (OPTIONAL) The external link type associated with the default route advertised into a routing domain. Specify one of the following: ● external ● internal (OPTIONAL) Routes are independently redistributed into IS-IS as Level 1 routes. (OPTIONAL) Routes are independently redistributed into IS-IS as Level-1-2 routes. (OPTIONAL) Routes are independently redistributed into IS-IS as Level 2 routes. This setting is the default. (OPTIONAL) If you do not enter the route-map argument, all routes are redistributed. If a map-name value is not specified, no routes are imported. Defaults ● metric metric-value = 0 ● metric-type= internal; level-2 Command Modes ● ROUTER ISIS (for IPv4) ● CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6) Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.0.2.0 8.3.19.0 8.3.11.1 8.3.12.0 7.5.1.0 6.3.1.0 Introduced on the C9010. Introduced on the S6000. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Added support for IPv6 ISIS. Introduced. Usage Information To redistribute a default route (0.0.0.0/0), configure the default-information originate command. Changing or disabling a keyword in this command does not affect the state of the other command keywords. When an LSP with an internal metric is received, the Dell Networking OS considers the route cost while considering the advertised cost to reach the destination. Redistributed routing information is filtered with the distribute-list out command to ensure that the routes are properly passed to the receiving routing protocol. How a metric value assigned to a redistributed route is advertised depends on how on the configuration of the metric-style command. If the metric-style command is set for Narrow or Transition mode and the metric value in the redistribute command is set to a number higher than 63, the metric value advertised in LSPs is 63. If the metric-style command is set for Wide mode, the metric value in the redistribute command is advertised. Intermediate System to Intermediate System (IS-IS) 849