Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 203

Related Commands ● Multi-supplicant mode authenticates every device attempting to connect to the network on the authenticator port. ● Use this command in Interface Batch Mode to enable single-host or multi-host authentication in a dual-homing setup. show dot1x interface dot1x mac-auth-bypass Enable MAC authentication bypass. If 802.1X times out because the host did not respond to the Identity Request frame, the system attempts to authenticate the host based on its MAC address. C9000 Series Syntax dot1x mac-auth-bypass To disable MAC authentication bypass on a port, use the no dot1x mac-auth-bypass command. Defaults Disabled Command Modes INTERFACE INTERFACE (BATCH MODE) Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.10(0.0) 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.12.0 8.3.11.1 8.4.1.0 Introduced the Configuration Terminal Batch mode on C9010. Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the S4810. Introduced on the Z9000. Introduced on the C-Series and S-Series. Related Commands dot1x auth-type mab-only dot1x max-eap-req Configure the maximum number of times an extensive authentication protocol (EAP) request is transmitted before the session times out. C9000 Series Syntax dot1x max-eap-req number To return to the default, use the no dot1x max-eap-req command. 802.1X 203