Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 94

reload Reboot the system. C9000 Series Syntax Parameters reload [conditional nvram-cfg-change | pe pe-id] From a PE console, use reload to perform a cold restart. conditional nvram-cfgchange pe Reload if the condition is true. A configuration change to the nvram requires a switch reload. To reload the switch, select nvram-cfg-change. Reload the RMP, PE unit, or the entire PE stack configured under that PE unit. Command Modes EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.2(1.0) 9.1(0.0) 8.3.19.0 8.3.11.1 7.6.1.0 7.5.1.0 E-Series Introduced on the C9010 and C1048P. Introduced on the Z9500. Added 'conditional' parameter. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S-Series. Introduced on the C-Series. Original command. Usage Information If there is a change in the configuration, the system prompts you to save the new configuration. Or you can save your running configuration with the copy running-config command. Use the conditional parameter if any configuration changes made to the nvram, such as stack-group and fanout configurations, must be saved. To halt a port extender (PE) or an entire PE stack, and perform a cold-restart (from a PE console), use the reload command. send Send messages to one or all terminal line users. C9000 Series Syntax Parameters send [*] | [line ] | [console] | [vty] * line console Enter the asterisk character * to send a message to all tty lines. Send a message to a specific line. The range is from 0 to 11. Enter the keyword console to send a message to the primary terminal line. 94 Control and Monitoring