Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 1181

ip ospf retransmit-interval Set the retransmission time between lost link state advertisements (LSAs) for adjacencies belonging to the interface. C9000 Series Syntax Parameters ip ospf retransmit-interval seconds To return to the default values, use the no ip ospf retransmit-interval command. seconds Enter the number of seconds as the interval between retransmission. The range is from 1 to 3600. The default is 5 seconds. This interval must be greater than the expected round-trip time for a packet to travel between two routers. Defaults 5 seconds Command Modes INTERFACE Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 7.6.1.0 7.5.1.0 6.1.1.1 Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Usage Information Set the time interval to a number large enough to prevent unnecessary retransmissions. For example, the interval must be larger for interfaces connected to virtual links. ip ospf transmit-delay To send a link state update packet on the interface, set the estimated time elapsed. C9000 Series Syntax Parameters ip ospf transmit-delay seconds To return to the default value, use the no ip ospf transmit-delay command. seconds Enter the number of seconds as the interval between retransmission. The range is from 1 to 3600. The default is 1 second. This value must be greater than the transmission and propagation delays for the interface. Defaults 1 second Command Modes INTERFACE Open Shortest Path First (OSPFv2 and OSPFv3) 1181