Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 739

When rate-interval is configured at the interface level and not in the global configuration mode, the interface level rate-interval value is applied for an interface. When rate interval is configured in both global configuration mode as well as interface mode, then the rate-interval value configured at interface level is applied as it takes precedence over the global value. show config Display the interface configuration. C9000 Series Syntax show config Command Modes INTERFACE Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 8.1.1.0 7.6.1.0 7.5.1.0 6.2.1.0 Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the E-Series ExaScale. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Example Dell(conf)#int peg 255/1/0 Dell(conf-if-pegi-255/1/0)#sho con ! interface peGigE 255/1/0 dampening 20 200 800 80 no shutdown Dell(conf-if)# show conf ! interface TenGigabitEthernet 1/7 no ip address switchport no shutdown Dell(conf-if)# Interfaces 739