Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 1490

ip split-horizon Enable split-horizon for RIP data on the interface. As described in RFC 2453, the split-horizon scheme prevents any routes learned over a specific interface to be sent back out that interface. C9000 Series Syntax ip split-horizon To disable split-horizon, use the no ip split-horizon command. Defaults Enabled Command Modes INTERFACE Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 7.8.1.0 7.6.1.0 6.2.1.1 Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Related Commands ip poison-reverse - sets the prefix for RIP routing updates. maximum-paths Set RIP to forward packets over multiple paths. C9000 Series Syntax Parameters maximum-paths number To return to the default values, use the no maximum-paths commands. number Enter the number of paths. The range is from 1 to 16. The default is 4 paths. Defaults 4 Command Modes ROUTER RIP Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. 1490 Routing Information Protocol (RIP)