Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 100
dot1x guest-vlan
View all Dell S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 100 highlights
www.dell.com | support.dell.com dot1x guest-vlan s S6000 Configure a guest VLAN for limited access users or for devices that are not 802.1X capable. Syntax Parameters Defaults Command Modes Command History Usage Information dot1x guest-vlan vlan-id To disable the guest VLAN, use the no dot1x guest-vlan vlan-id command. vlan-id Enter the VLAN Identifier. Range: 1 to 4094 Not configured CONFIGURATION (conf-if-interface-slot/port) Version 9.0.2.0 Version 8.3.12.0 Version 8.4.1.0 Introduced on S6000 Introduced on the S4810. Introduced on S-Series 802.1X authentication is enabled when an interface is connected to the switch. If the host fails to respond within a designated amount of time, the authenticator places the port in the guest VLAN. If a device does not respond within 30 seconds, it is assumed that the device is not 802.1X capable. Therefore, a guest VLAN is allocated to the interface and authentication, for the device, will occur at the next re-authentication interval (dot1x reauthentication). If the host fails authentication for the designated amount of times, the authenticator places the port in authentication failed VLAN (dot1x auth-fail-vlan). Note: Layer 3 portion of guest VLAN and authentication fail VLANs can be created regardless if the VLAN is assigned to an interface or not. Once an interface is assigned a guest VLAN (which has an IP address), then routing through the guest VLAN is the same as any other traffic. However, interface may join/leave a VLAN dynamically. Related Commands dot1x auth-fail-vlan dot1x reauthentication dot1x reauth-max Configure an authentication failure VLAN. Enable periodic re-authentication of the client. Configure the maximum number of times to re-authenticate a port before it becomes unauthorized. 100 | 802.1X