Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 274

www.dell.com | support.dell.com detail flap-statistics routes received-routes [network [network-mask] denied-routes [network [network-mask] (OPTIONAL) Enter the keyword detail to view neighbor-specific internal information for the IPv4 Unicast address family. (OPTIONAL) Enter the keyword flap-statistics to view flap statistics on the neighbor's routes. (OPTIONAL) Enter the keywords routes to view only the neighbor's feasible routes. (OPTIONAL) Enter the keywords received-routes followed by either the network address (in dotted decimal format) or the network mask (in slash prefix format) to view all information received from neighbors. Note: neighbor soft-reconfiguration inbound must be configured prior to viewing all the information received from the neighbors. (OPTIONAL) Enter the keywords denied-routes followed by either the network address (in dotted decimal format) or the network mask (in slash prefix format) to view all information on routes denied via neighbor inbound filters. Command Modes EXEC EXEC Privilege Usage After a peer reset, the contents of the notification log messages will be displayed in hex values for Information debugging. Command History Version 9.0.2.0 Version 8.3.11.1 Version 7.8.1.0 Version 8.3.8.0 Version 7.8.1.0 Version 7.5.1.0 Version 7.2.1.0 Version 6.3.10 Introduced on the S6000. Introduced on the Z9000. Introduced support on S-Series Added the add-path option to the S4810. Output on the S4810 shows ADDPATH parameters. Introduced support on S-Series Added detail option and output now displays default MED value Added received and denied route options The output is changed to display the total number of advertised prefixes Example FTOS# Example 1 Figure 9-15. Command Example: show ip bgp neighbors on the S4810(Partial) FTOS#show ip bgp neighbors BGP neighbor is 10.10.10.1, remote AS 23456, external link BGP version 4, remote router ID 10.10.10.1 BGP state ESTABLISHED, in this state for 00:00:35 . . . Capabilities received from neighbor for IPv4 Unicast : MULTIPROTO_EXT(1) ROUTE_REFRESH(2) 4_OCTECT_AS(65) ADD_PATH (69) CISCO_ROUTE_REFRESH(128) Figure 9-16. Command Example: show ip bgp neighbors (Partial) FTOS#show ip bgp neighbors BGP neighbor is 100.10.10.2, remote AS 200, external link BGP version 4, remote router ID 192.168.2.101 BGP state ESTABLISHED, in this state for 00:16:12 Last read 00:00:12, last write 00:00:03 274 | Border Gateway Protocol