Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 944
vlan-stack trunk, vlan-stack protocol-type, switch port, no member
View all Dell S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 944 highlights
www.dell.com | support.dell.com Syntax vlan-stack protocol-type number Parameters number Enter the hexadecimal number as the Stackable VLAN tag. On the S-Series: You may specify both bytes of the 2-byte S-Tag TPID. S-Series Range: 0 to FFFF Default: 9100 Defaults 0x9100 Command Modes CONFIGURATION Command History Version 9.0.2.0 Version 8.3.11.1 Version 8.3.7.0 Introduced on S6000. Introduced on Z9000. Introduced on S4810. Usage See the FTOS Configuration Guide for specific interoperability limitations regarding the S-Tag TPID. Information Related Commands portmode hybrid vlan-stack trunk Set a port (physical ports only) to accept both tagged and untagged frames. A port configured this way is identified as a hybrid port in report displays. Specify a Layer 2 port or port channel as a trunk port to the Stackable VLAN network. vlan-stack trunk z S6000 Specify a Layer 2 port or port channel as a trunk port to the Stackable VLAN network. Syntax vlan-stack trunk To remove a trunk port designation from the selected interface, enter no vlan-stack trunk. Defaults Not configured. Command Modes INTERFACE Command History Version 9.0.2.0 Version 8.3.11.1 Version 8.3.7.0 Introduced on S6000. Introduced on Z9000. Introduced on S4810. Usage Prior to using this command, you must execute the switch port command to place the interface in Information Layer 2 mode. To remove the trunk port designation, the port must first be removed (using the no member interface command) from all Stackable VLAN-enabled VLANs. Starting with the VLAN-Stack trunk port can transparently tunnel, in a service provider environment, customer-originated xSTP control protocol PDUs. See Chapter 40, Service Provider Bridging. 944 | VLAN Stacking