Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 680

www.dell.com | support.dell.com Backup Designated Router (ID) 192.168.253.3, Interface address 192.168.0.2 Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5 Hello due in 00:00:08 Neighbor Count is 3, Adjacent neighbor count is 2 Adjacent with neighbor 192.168.253.5 (Designated Router) Adjacent with neighbor 192.168.253.3 (Backup Designated Router) Loopback 0 is up, line protocol is up Internet Address 192.168.253.2/32, Area 0.0.0.1 Process ID 1, Router ID 192.168.253.2, Network Type LOOPBACK, Cost: 1 Loopback interface is treated as a stub Host. FTOS> Table 29-10. Command Example Descriptions: show ip ospf process-id interface Line beginning with GigabitEthernet... Internet Address... Process ID... Transmit Delay... Designated Router... Backup Designated... Timer intervals... Hello due... Neighbor Count... Description This line identifies the interface type slot/port and the status of the OSPF protocol on that interface. This line displays the IP address, network mask and area assigned to this interface. This line displays the OSPF Process ID, Router ID, Network type and cost metric for this interface. This line displays the interface's settings for Transmit Delay, State, and Priority. In the State setting, BDR is Backup Designated Router. This line displays the ID of the Designated Router and its interface address. This line displays the ID of the Backup Designated Router and its interface address. This line displays the interface's timer settings for Hello interval, Dead interval, Transmit Delay (Wait), and Retransmit Interval. This line displays the amount time till the next Hello packet is sent out this interface. This line displays the number of neighbors and adjacent neighbors. Listed below this line are the details about each adjacent neighbor. 680 | Open Shortest Path First (OSPFv2)