Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 684

www.dell.com | support.dell.com Table 29-12. Command Example Descriptions: show ip ospf statistics process-id global Row Heading LSR-Q Other-Q Description The queue, for transmission or reception, for the link state request packets. The queue, for transmission or reception, for the link state acknowledgement, database description, and update packets. Table 29-13. Error Definitions: show ip ospf statistics process-id global Error Type Intf_Down Non-Dr Self-Org Wrong_Len Invld-Nbr Nbr-State Auth-Error MD5-Error Cksum-Err Version AreaMismatch Conf-Issue No-Buffer Seq-no Socket Q-overflow Unknown-Pkt Description Received packets on an interface that is either down or OSPF is not enabled. Received packets with a destination address of ALL_DRS even though SELF is not a designated router Receive the self originated packet The received packet length is different to what was indicated in the OSPF header LSA, LSR, LSU, and DDB are received from a peer which is not a neighbor peer LSA, LSR, and LSU are received from a neighbor with stats less than the loading state Simple authentication error MD5 error Checksum Error Version mismatch Area mismatch The received hello packet has a different hello or dead interval than the configuration Buffer allocation failure A sequence no errors occurred during the database exchange process Socket Read/Write operation error Packet(s) dropped due to queue overflow Received packet is not an OSPF packet The show ip ospf process-id statistics command displays the error packet count received on each interface as: • The hello-timer remaining value for each interface • The wait-timer remaining value for each interface • The grace-timer remaining value for each interface • The packet count received and transmitted for each neighbor • Dead timer remaining value for each neighbor • Transmit timer remaining value for each neighbor • The LSU Q length and its highest mark for each neighbor • The LSR Q length and its highest mark for each neighbor Example Figure 29-18. Command Example: show ip ospf process-id statistics FTOS#show ip ospf 100 statistics 684 | Open Shortest Path First (OSPFv2)