Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 429

interface range macro name s z S6000 Run the interface-range macro to automatically configure the pre-defined range of interfaces. Syntax interface range macro name Parameters name Enter the name of an existing macro. Defaults This command has no default behavior or value Command Modes CONFIGURATION Command History Version 9.0.2.0 Version 8.3.11.1 Version 8.2.1.0 Introduced on then S6000. Introduced on the Z9000. Introduced on the S4810 Usage Information Figure 20-14 runs the macro named test that was defined in Figure 20-13. Example Related Commands Figure 20-14. interface-range macro Command Example FTOS(config)#interface range macro test FTOS(config-if-range-te-0/0-3,gi-5/0-47,gi-13/0-89)# FTOS interface range interface range macro (define) Configure a range of command (bulk configuration) Define a macro for an interface range (bulk configuration) interface vlan s z S6000 Configure a VLAN. You can configure up to 4094 VLANs. Syntax interface vlan vlan-id To delete a VLAN, use the no interface vlan vlan-id command. Parameters vlan-id Enter a number as the VLAN Identifier. Range: 1 to 4094. Defaults Not configured, except for the Default VLAN, which is configured as VLAN 1. Command Modes CONFIGURATION Command History Version 9.0.2.0 Version 8.3.11.1 Version 8.2.1.0 Introduced on then S6000. Introduced on the Z9000. Introduced on the S-Series Example Figure 20-15. interface vlan Command Example FTOS(conf)#int vlan 3 FTOS(conf-if-vl-3)# Interfaces | 429