Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 942

www.dell.com | support.dell.com Usage Information Warning: The following message is displayed to confirm the command: All non-default configurations on the related member ports ports () will be removed. Do you want to continue (y/n)? If "y" is entered, all non-default configurations on any member ports of the current stack group will be removed when the unit is rebooted. vlan-stack access z S6000 Specify a Layer 2 port or port channel as an access port to the Stackable VLAN network. Syntax vlan-stack access To remove access port designation, enter no vlan-stack access. Defaults Not configured. Command Modes INTERFACE Command History Version 9.0.2.0 Version 8.3.11.1 Introduced on S6000. Introduced on Z9000 Usage Prior to enabling this command, you must enter the switch port command to place the interface in Information Layer 2 mode. To remove the access port designation, the port must be removed (using the no member interface command) from all Stackable VLAN enabled VLANs. vlan-stack compatible z S6000 Enable the Stackable VLAN feature on a VLAN. Syntax vlan-stack compatible To disable the Stackable VLAN feature on a VLAN, enter no vlan-stack compatible. Defaults Not configured. Command Modes CONF-IF-VLAN Command History Version 9.0.2.0 Version 8.3.11.1 Version 8.3.7.0 Introduced on S6000. Introduced on Z9000. Introduced on S4810. 942 | VLAN Stacking