Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 430
keepalive, monitor
View all Dell S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 430 highlights
www.dell.com | support.dell.com Usage Information For more information on VLANs and the commands to configure them, refer to Virtual LAN (VLAN) Commands. FTP, TFTP, and SNMP operations are not supported on a VLAN. MAC ACLs are not supported in VLANs. IP ACLs are supported. See Chapter 6, Access Control Lists (ACL). Related Commands interface interface loopback interface null interface port-channel show vlan shutdown tagged untagged Configure a physical interface. Configure a loopback interface. Configure a null interface. Configure a port channel group. Display the current VLAN configuration on the switch. Disable/Enable the VLAN. Add a Layer 2 interface to a VLAN as a tagged interface. Add a Layer 2 interface to a VLAN as an untagged interface. keepalive s z S6000 Send the keepalive packets periodically, by default 10seconds to keep an interface alive when it is not transmitting data. Syntax keepalive To stop sending keepalive packets, enter no keepalive. Defaults Disabled Command Modes INTERFACE Command History Version 9.0.2.0 Version 8.3.11.1 Version 8.2.1.0 Introduced on then S6000. Introduced on the Z9000. Introduced on the S4810 Usage Information When you configure keepalive, the system sends a self-addressed packet out of the configured interface to verify that the far end of a WAN link is up. When you configure no keepalive, the system does not send keepalive packets and so the local end of a WAN link remains up even if the remote end is down. monitor s z S6000 Syntax Monitor counters on a single interface or all interfaces on a stack-unit. The screen is refreshed every 5 seconds and the CLI prompt disappears. monitor interface [interface] To disable monitoring and return to the CLI prompt, press the q key. 430 | Interfaces