Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 486

www.dell.com | support.dell.com Parameters ip-selection {dest-ip | source-ip} mac {dest-mac | source-dest-mac | source-mac} tcp-udp enable Enter the keywords to distribute IP traffic based on the following criteria: • dest-ip-Uses destination IP address and destination port fields to hash. The hashing mechanism returns a 3-bit index indicating which port the packet should be forwarded to. • source-ip-Uses source IP address and source port fields to hash. The hashing mechanism returns a 3-bit index indicating which port the packet should be forwarded to. Enter the keywords to distribute MAC traffic based on the following criteria: • dest-mac-Uses the destination MAC address, VLAN, Ethertype, source module ID and source port ID fields to hash. The hashing mechanism returns a 3-bit index indicating which port the packet should be forwarded to. • source-dest-mac-Uses the destination and source MAC address, VLAN, Ethertype, source module ID and source port ID fields to hash. The hashing mechanism returns a 3-bit index indicating which port the packet should be forwarded to. • source-mac-Uses the source MAC address, VLAN, Ethertype, source module ID and source port ID fields to hash. The hashing mechanism returns a 3-bit index indicating which port the packet should be forwarded to. Enter the keywords to distribute traffic based on the following: • enable-Takes the TCP/UDP source and destination ports into consideration when doing hash computations. (By default, this is enabled) Defaults IP 4-tuple (IP SA, IP DA, Source Port, Destination Port) Command Modes CONFIGURATION Command History Version 9.0.2.0 Version 8.3.11.1 Introduced on the S6000. Introduced on Z9000 Usage Information By default, FTOS distributes incoming traffic based on a hash algorithm using the following criteria: • IP source address • IP destination address • TCP/UDP source port • TCP/UDP destination port Related Commands hash-algorithm Change the hash algorithm used to distribute traffic flows across a Port Channel. load-balance hg z S6000 Choose the traffic flow parameters to be used in the hash calculation while distributing the traffic across internal higig links. Syntax [no] load-balance hg { ip-selection | ipv6-selection [source-ip | source-ipv6 | source-port-id | source-module-id | dest-ip | dest-ipv6 | dest-port-id | dest-module-id | protocol | vlan | L4-source-port | L4-dest-port ] | mac [source-mac | source-port-id | source-module-id | dest-mac | dest-port-id | dest-module-id | vlan | ethertype | source-dest-mac] | tunnel [ipv4-over-ipv4 | ipv4-over-gre-ipv4 | mac-in-mac]} 486 | IPv4 Routing