Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 557
show isis protocol, show isis traffic, Command Example
View all Dell S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 557 highlights
show isis protocol S6000 Display IS-IS routing information. Syntax show isis protocol Command Modes EXEC EXEC privilege Command History Version 9.0.2.0 Version 8.3.8.0 Introduced on the S6000. Introduced for the S4810 Example Figure 23-9. Command Example: show isis protocol FTOS#show isis protocol IS-IS Router: System Id: F100.E120.0013 IS-Type: level-1-2 Manual area address(es): 49.0000.0001 Routing for area address(es): 49.0000.0001 Interfaces supported by IS-IS: GigabitEthernet 1/0 - IP - IPv6 GigabitEthernet 1/1 - IP - IPv6 GigabitEthernet 1/10 - IP - IPv6 Loopback 0 - IP - IPv6 Redistributing: Identifies that MT IS-IS is enabled. Distance: 115 Generate narrow metrics: level-1-2 Accept narrow metrics: level-1-2 Generate wide metrics: none Accept wide metrics: none Multi Topology Routing is enabled in transition mode. FTOS# show isis traffic S6000 This command enables you to display IS-IS traffic interface information. Syntax show isis traffic [interface] Parameters interface (OPTIONAL) Identifies the interface type slot/port as one of the following: • For a Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Port Channel, enter the keyword port-channel followed by a number from 1 to 32 for EtherScale, 1 to 255 for TeraScale. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a VLAN, enter the keyword vlan followed by a number from 1 to 4094. Command Modes EXEC EXEC privilege | 557