Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 423
interface loopback
View all Dell S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 423 highlights
Parameters interface Enter one of the following keywords and slot/port or number information: • For 100/1000 Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/port information. Defaults Not configured. Command Modes CONFIGURATION Command History Version 9.0.2.0 Version 8.3.11.1 Version 8.2.1.0 Introduced on then S6000. Introduced on the Z9000. Introduced on the S4810 Example Usage Information Figure 20-3. interface Command Example FTOS(conf)#interface gig 0/0 FTOS(conf-if-gi-0/0)#exit# You cannot delete a physical interface. By default, physical interfaces are disabled (shutdown) and are in Layer 3 mode. To place an interface in Layer2 mode, ensure that the interface's configuration does not contain an IP address and enter the switchport command. Related Commands interface loopback interface null interface port-channel interface vlan show interfaces Configure a Loopback interface. Configure a Null interface. Configure a port channel. Configure a VLAN. Display interface configuration. interface loopback s z S6000 Configure a Loopback interface. Syntax interface loopback number To remove a loopback interface, use the no interface loopback number command. Parameters number Enter a number as the interface number. Range: 0 to 16383. Defaults Not configured. Command Modes CONFIGURATION Interfaces | 423