Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 199
default-gateway, ignore enable-password
View all Dell S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 199 highlights
BOOT_USER # default-gateway S6000 Assign an IP address as the default gateway for the system. Syntax Parameters [no] default-gateway ip-address ip-address Enter the IP address of the gateway router in dotted decimal format (A.B.C.D). Defaults Not configured. Command Modes BOOT_USER Command History Usage Information Version 9.0.2.0 Introduced on the S6000. Use the show default-gateway command to view the current default gateway. Related Commands show default-gateway Change the primary, secondary or default boot image configuration. ignore enable-password S6000 Reload the system software without the enable password configured. Syntax ignore enable-password Defaults Not configured. Command Modes BOOT_USER Command History Version 9.0.2.0 Introduced on the S6000. Usage When you enter the reload command and the system reboots, you will not be prompted for a password Information to enter the EXEC Privilege mode (normally you are required to enter the enable command.) If your console or Telnet session expires after you used the ignore enable-password command, you are prompted for an enable password when you re-establish the session. Related Commands reload Exit from this mode and reload FTOS. Boot Command Line Interface (BCLI) | 199