Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 254
neighbor subnet
View all Dell S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 254 highlights
www.dell.com | support.dell.com To disable, use the no neighbor {ip-address | peer-group-name} soft-reconfiguration inbound command. Parameters ip-address peer-group-name Enter the IP address of the neighbor in dotted decimal format. Enter the name of the peer group to disable or enable all routers within the peer group. Defaults Disabled Command Modes ROUTER BGP Usage This command enables soft-reconfiguration for the BGP neighbor specified. BGP will store all the Information updates received by the neighbor but will not reset the peer-session. Caution: Inbound update storage is a memory-intensive operation. The entire BGP update database from the neighbor is stored in memory regardless of the inbound policy results applied on the neighbor. Related Commands Command History Note: This command is supported in BGP Router Configuration mode for IPv4 Unicast address only. show ip bgp neighbors Display routes received by a neighbor Version 9.0.2.0 Version 8.3.11.1 Version 7.8.1.0 Introduced on the S6000. Introduced on the Z9000. Introduced support on S-Series neighbor subnet s z S6000 Enable passive peering so that the members of the peer group are dynamic Syntax neighbor peer-group-name subnet subnet-number mask To remove passive peering, use the no neighbor peer-group-name subnet subnet-number mask command. Parameters subnet-number mask Enter a subnet number in dotted decimal format (A.B.C.D.) as the allowable range of addresses included in the Peer group. To allow all addresses, enter 0.0.0.0/0. Enter a prefix mask in / prefix-length format (/x). Defaults Not configured. Command Modes ROUTER BGP Command History Version 9.0.2.0 Introduced on the S6000. 254 | Border Gateway Protocol