Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 157
clear counters ipv6 access-group, Command Example
View all Dell S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 157 highlights
Parameters default l2acl 1-4 ipv4acl 1- 4 ipv6acl 0-4 Use the default CAM profile settings, and set the CAM as follows. L2 ACL(l2acl): 1 L3 ACL (ipv4acl): 1 IPv6 L3 ACL (ipv6acl): 2 Allocate space to support IPv6 ACLs. You must enter all of the profiles and a range for each. Enter the CAM profile name followed by the amount to be allotted. The total space allocated must equal 4. The ipv6acl range must be a factor of 2. Command Modes Command History CONFIGURATION Version 9.0.2.0 Version 8.3.7.0 Introduced on the S6000. Introduced on the S4810. Usage You must save the new CAM settings to the startup-config (write-mem or copy run start) then reload Information the system for the new settings to take effect. The total amount of space allowed is 4 FP Blocks. Example Figure 6-12. Command Example: cam-acl-egress FTOS# FTOS#configure FTOS(conf)#cam-acl-egress ? default Reset Egress CAM ACL entries to default setting l2acl Set L2-ACL entries FTOS(conf)#cam-acl-egress l2acl ? Number of FP blocks for l2acl FTOS(conf)#cam-acl-egress l2acl 1 ? ipv4acl Set IPV4-ACL entries FTOS(conf)#cam-acl-egress l2acl 1 ipv4acl 1 ? ipv6acl Set IPV6-ACL entries FTOS(conf)#cam-acl-egress l2acl 1 ipv4acl 1 ipv6acl ? Number of FP blocks for IPV6 (multiples of 2) FTOS(conf)#cam-acl-egress l2acl 1 ipv4acl 1 ipv6acl 2 clear counters ipv6 access-group s S6000 Erase all counters maintained for the IPv6 access lists. Syntax clear counters ipv6 access-group [access-list-name] Parameters access-list-name (OPTIONAL) Enter the name of a configured access-list, up to 140 characters. Command Modes EXEC EXEC Privilege Command History Version 9.0.2.0 Version 8.3.7.0 Introduced on the S6000. Introduced on the S4810. Access Control Lists (ACL) | 157