Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 478

www.dell.com | support.dell.com %Error: port operator RANGE not supported in access-list debug %Error: port operator NEQ not supported in access-list debug FTOS#00:10:45: %RPM0-P:CP %IPMGR-3-DEBUG_IP_PACKET_ACL_AMBIGUOUS_EXP: Ambiguous rules not supported in access-list debug, access-list debugging is turned off FTOS# ip address z S6000 Assign a primary and secondary IP address to the interface. Syntax ip address ip-address mask [secondary] To delete an IP address from an interface, use the no ip address [ip-address] command. Parameters ip-address mask secondary Enter an IP address in dotted decimal format. Enter the mask of the IP address in slash prefix format (for example, /24). (OPTIONAL) Enter the keyword secondary to designate the IP address as the secondary address. Defaults Not configured. Command Modes INTERFACE Command History Version 9.0.2.0 Version 8.3.11.1 Introduced on the S6000. Introduced on Z9000. Usage Information You must be in the INTERFACE mode before you add an IP address to an interface. Assign an IP address to an interface prior to entering the ROUTER OSPF mode. ip directed-broadcast z S6000 Enables the interface to receive directed broadcast packets. Syntax ip directed-broadcast To disable the interface from receiving directed broadcast packets, enter no ip directed-broadcast. Defaults Disabled (that is, the interface does not receive directed broadcast packets) Command Modes INTERFACE Command History Version 9.0.2.0 Version 8.3.11.1 Introduced on the S6000. Introduced on Z9000 478 | IPv4 Routing