Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 258

www.dell.com | support.dell.com To remove a network, use the no network ip-address mask backdoor command. Parameters ip-address mask Enter an IP address in dotted decimal format of the network. Enter the mask of the IP address in the slash prefix length format (for example, /24). The mask appears in command outputs in dotted decimal format (A.B.C.D). Defaults Not configured. Command Modes ROUTER BGP Usage Though FTOS does not generate a route due to backdoor config, there is an option for injecting/ Information sourcing a local route in presence of network backdoor config on a learned route. Command History Version 9.0.2.0 Version 8.3.11.1 Version 7.8.1.0 Introduced on the S6000. Introduced on the Z9000. Introduced support on S-Series redistribute s z S6000 Redistribute routes into BGP. Syntax redistribute {connected | static} [route-map map-name] To disable redistribution, use the no redistribution {connected | static} command. Parameters connected static route-map map-name Enter the keyword connected to redistribute routes from physically connected interfaces. Enter the keyword static to redistribute manually configured routes. These routes are treated as incomplete routes. (OPTIONAL) Enter the keyword route-map followed by the name of an established route map. Only the following ROUTE-MAP mode commands are supported: • match ip address • set community • set local-preference • set metric • set next-hop • set origin • set weight If the route map is not configured, the default is deny (to drop all routes). Defaults Not configured. Command Modes ROUTER BGP 258 | Border Gateway Protocol