Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 485
ip source-route, ip unreachables, load-balance
View all Dell S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 485 highlights
ip source-route z S6000 Enable FTOS to forward IP packets with source route information in the header. Syntax ip source-route To drop packets with source route information, enter no ip route-source. Defaults Enabled. Command Modes CONFIGURATION Command History Version 9.0.2.0 Version 8.3.11.1 Introduced on the S6000. Introduced on Z9000 ip unreachables z S6000 Enable the generation of Internet Control Message Protocol (ICMP) unreachable messages. Syntax ip unreachables To disable the generation of ICMP messages, enter no ip unreachables. Defaults Disabled Command Modes INTERFACE Command History Version 9.0.2.0 Version 8.3.11.1 Introduced on the S6000. Introduced on Z9000 load-balance z S6000 By default for S-Series, FTOS uses an IP 4-tuple (IP SA, IP DA, Source Port, and Destination Port) to distribute IP traffic over members of a Port Channel as well as equal-cost paths. To designate another method to balance traffic over Port Channel members, use the load-balance command. Syntax load-balance {ip-selection [dest-ip | source-ip]} | {mac [dest-mac | source-dest-mac | source-mac]} | {tcp-udp [enable]} To return to the default setting (IP 4-tuple), use the no version of the command. IPv4 Routing | 485