Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 309

FTOS# test cam-usage z S6000 Verify that enough CAM space is available for the IPv6 ACLs you have created. Syntax test cam-usage service-policy input input policy name linecard {number | all} Parameters policy-map name number Enter the name of the policy-map to verify. Enter all to get information for all the linecards/stack-units, or enter the linecard/ stack-unit number to get information for a specific card. Range: 0-11 for S4810; 0-7 for all other S-Series Defaults None Command Modes EXEC Privilege Command History Version 9.0.2.0 Introduced on the S6000. version 9.0.0.0 Introduced on the Z9000. Usage This command applies to both IPv4 and IPv6 CAM Profiles, but is best used when verifying QoS Information optimization for IPv6 ACLs. QoS Optimization for IPv6 ACLs does not impact the CAM usage for applying a policy on a single (or the first of several) interfaces. It is most useful when a policy is applied across multiple interfaces; it can reduce the impact to CAM usage across subsequent interfaces. Example The following examples show some sample output when using the test cam-usage command. Figure 11-3. Command Example: test cam-usage (S-Series) FTOS#test cam-usage service-policy input LauraIn stack-unit all Stack-Unit | Portpipe | CAM Partition | Available CAM | Estimated CAM per Port | Status 0 | 0 | IPv4Flow | 102 | 0 | Allowed 0 | 1 | IPv4Flow | 102 | 0 | Allowed FTOS# ! FTOS#test cam-usage service-policy input LauraIn stack-unit 0 port-set 1 Stack-Unit | Portpipe | CAM Partition | Available CAM | Estimated CAM per Port | Status 0 | 1 | IPv4Flow | 102 | 0 | Allowed FTOS# Content Addressable Memory (CAM) | 309