Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 738

www.dell.com | support.dell.com On one interface, you can configure the rate police command for a VLAN or you can configure the rate police command for an interface. For each physical interface, you can configure three rate police commands specifying different VLANS. rate shape z S6000 Shape the traffic output on the selected interface. Syntax rate shape [kbps] rate [burst-KB] Parameters kbps rate burst-KB Enter this keyword to specify the rate limit in Kilobits per second (Kbps). On S-Series make the following value a multiple of 64. The default granularity is Megabits per second (Mbps). Range: 0 to 40000. Enter the outgoing rate in multiples of 10 Mbps. Range: 0 to 40000 (OPTIONAL) Enter a number as the burst size in KB. Range: 0 to 10000 Default: 50 Defaults Granularity for rate is Mbps unless the kbps option is used. Command Modes INTERFACE Command History Version 9.0.2.0 Version 8.3.11.1 Introduced on the S6000. Introduced on Z9000 Related Commands rate-shape Shape traffic output as part of the designated policy. service-class dynamic dot1p s z S6000 Honor all 802.1p markings on incoming switched traffic on an interface (from INTERFACE mode) or on all interfaces (from CONFIGURATION mode). A CONFIGURATION mode entry supersedes INTERFACE mode entries. Syntax service-class dynamic dot1p To return to the default setting, enter no service-class dynamic dot1p. 738 | Quality of Service (QoS)