Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 320

www.dell.com | support.dell.com By default, equal bandwidth is assigned to each priority group in the ETS output policy applied to an egress port if no bandwidth allocation is configured. The sum of configured bandwidth allocation to dot1p priority traffic in all ETS priority groups must be 100%. You must allocate at least 1% of the total bandwidth to each priority group and queue. If bandwidth is assigned to some priority groups but not to others, the remaining bandwidth (100% minus assigned bandwidth amount) is equally distributed to non-strict-priority groups which have no configured scheduler. clear ets counters S6000 Clear all ETS TLV counters on an interface. Syntax clear ets counters port-type slot/port Parameters port-type Enter the keyword port-type followed by the slot/port information. Defaults none Command Modes EXEC Privilege Command History Version 9.0.2.0 Version 8.3.16.0 Introduced on the S6000. Introduced on MXL 10/40GbE Switch IO Module clear pfc counters S6000 Clear the PFC TLV counters and PFC statistics on an interface or stack unit. Syntax clear pfc counters [port-type slot/port | stack-unit {unit number | all } all stack-ports all}]] Parameters port-type stack-unit unit number all stack-ports all Enter the keyword port-type followed by the slot/port information. Enter the keyword stack-unit followed by the stack-unit number to be cleared. Enter the keyword all stack-ports all to clear the counters on all interfaces. Defaults none Command Modes EXEC Privilege Command History Version 9.0.2.0 Version 8.3.16.0 Introduced on the S6000. Introduced on MXL 10/40GbE Switch IO Module dcb-enable S6000 Enable Data Center Bridging. Syntax dcb enable[pfc-queues 1|2] 320 | Data Center Bridging (DCB)