Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 943
vlan-stack dot1p-mapping, vlan-stack protocol-type
View all Dell S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 943 highlights
Usage Information You must remove the members prior to disabling the Stackable VLAN feature. To view the Stackable VLANs, use the show vlan command in the EXEC Privilege mode. Stackable VLANs contain members, designated by the M in the Q column of the command output. Figure 46-1. show vlan Command Example with Stackable VLANs FTOS#show vlan Codes: * - Default VLAN, G - GVRP VLANs NUM * 1 2 3 Status Inactive Active Active 4 Active 5 Active M Gi 13/18 FTOS# Q Ports M Gi 13/13 M Gi 13/0-2 M Po1(Gi 13/14-15) M Gi 13/18 M Gi 13/3 M Po1(Gi 13/14-15) M Gi 13/18 M Gi 13/4 M Po1(Gi 13/14-15) M Gi 13/5 vlan-stack dot1p-mapping z S6000 Map C-Tag dot1p values to a S-Tag dot1p value. C-Tag values may be separated by commas, and dashed ranges are permitted. Dynamic Mode CoS overrides any Layer 2 QoS configuration in case of conflicts. Syntax vlan-stack dot1p-mapping c-tag-dot1p values sp-tag-dot1p value Parameters c-tag-dot1p value sp-tag-dot1p value Enter the keyword followed by the customer dot1p value that will be mapped to a service provider do1p value. Range: 0-7 Enter the keyword followed by the service provider dot1p value. Range: 0-7 Defaults None Command Modes INTERFACE Command History Version 9.0.2.0 Version 8.3.11.1 Version 8.3.7.0 Introduced on S6000. Introduced on Z9000. Introduced on S4810. vlan-stack protocol-type z S6000 Define the Stackable VLAN Tag Protocol Identifier (TPID) for the outer VLAN tag (also called the VMAN tag). If you do not configure this command, FTOS assigns the value 0x9100. VLAN Stacking | 943