Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 253
neighbor shutdown, neighbor soft-reconfiguration inbound
View all Dell S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 253 highlights
Defaults Not configured and COMMUNITY attributes are not sent to neighbors. Command Modes ROUTER BGP Usage To configure a COMMUNITY attribute, use the set community command in the ROUTE-MAP mode. Information Command History Version 9.0.2.0 Version 8.3.11.1 Version 7.8.1.0 Introduced on the S6000. Introduced on the Z9000. Introduced support on S-Series neighbor shutdown s z S6000 Disable a BGP neighbor or peer group. Syntax neighbor {ip-address | peer-group-name} shutdown To enable a disabled neighbor or peer group, use the neighbor {ip-address | peer-group-name} no shutdown command. Parameters ip-address peer-group-name Enter the IP address of the neighbor in dotted decimal format. Enter the name of the peer group to disable or enable all routers within the peer group. Defaults Enabled (that is, BGP neighbors and peer groups are disabled.) Command Modes ROUTER BGP Usage Information Peers that are enabled within a peer group are disabled when their peer group is disabled. The neighbor shutdown command terminates all BGP sessions on the BGP neighbor or BGP peer group. Use this command with caution as it terminates the specified BGP sessions. When a neighbor or peer group is shutdown, use the show ip bgp summary command to confirm its status. Related Commands show ip bgp summary show ip bgp neighbors Displays the current BGP configuration. Displays the current BGP neighbors. Command History Version 9.0.2.0 Version 8.3.11.1 Version 7.8.1.0 Introduced on the S6000. Introduced on the Z9000. Introduced support on S-Series neighbor soft-reconfiguration inbound s z S6000 Enable soft-reconfiguration for BGP. Syntax neighbor {ip-address | peer-group-name} soft-reconfiguration inbound Border Gateway Protocol | 253