Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 197
boot message, boot zero
View all Dell S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 197 highlights
To view the current boot configuration, use the show bootvar command. Related Commands boot zero show bootvar Remove the primary, secondary, or default boot image configuration. Display boot configuration information. boot message S6000 Use this command to enable/disable boot logs during reload. Syntax boot message on| off Parameters Command Modes on Enter the keyword on to turn on boot logs during reload. off Enter the keyword off to suppress the boot logs during reload. Note: By default, watchdog is disabled. BOOT_USER Command History Version 9.0.2.0 Introduced on the S6000. Example BOOT_USER #boot message boot messages off BOOT_USER # boot zero S6000 Erase the configured primary, secondary, or default boot image parameters. If you erase all three parameters, the S6000 switch boots from its internal Flash. Syntax boot zero {primary | secondary | default} Parameters primary secondary default Enter the keyword primary to configure the boot parameters used in the first attempt to boot the system. Enter the keyword secondary to configure boot parameters used if the primary operating system boot selection is not available. Enter the keyword default to configure boot parameters used if the secondary operating system boot parameter selection is not available. You can configure this option to any of the available type, for example flash/usb/ftp/tftp. Defaults Not configured. Command Modes BOOT_USER Command History Version 9.0.2.0 Introduced on the S6000. Boot Command Line Interface (BCLI) | 197