Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 867
sflow enable Global, sflow enable Interface
View all Dell S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 867 highlights
Command History Version 9.0.2.0 Version 8.3.11.1 Version 7.7.1.0 Version 6.5.1.0 Introduced on S6000 Introduced on Z9000 Introduced on S-Series Expanded the no form of the command to mirror the syntax used to configure Usage Information You can specify up to 2 sFlow collectors. If 2 collectors are specified, the samples are sent to both. In sFlow the agent address is a single invariant IPv4 or IPv6 addressed used to identify the agent to the collector. It is frequently assigned the address of a loopback interface on the agent, which provides invariance. The agent address is carried as a field in the payload of the sFlow packets. As part of the sFlow-MIB, if the SNMP request originates from a configured collector, FTOS will return the corresponding configured agent IP in MIB requests. FTOS checks to ensure that two entries are not configured for the same collector IP with a different agent IP. Should that happen, FTOS generates the following error: %Error: Different agent-addr attempted for an existing collector sflow enable (Global) s z S6000 Enable sFlow globally. Syntax sflow enable To disable sFlow, use the no sflow enable command. Defaults sFlow is disabled by default Command Modes CONFIGURATION Command History Version 9.0.2.0 Version 8.3.11.1 Version 7.7.1.0 Introduced on S6000 Introduced on Z9000 Introduces on S-Series Stacking Usage sFlow is disabled by default. In addition to this command, sFlow needs to be enable on individual Information interfaces where sFlow sampling is desired. Related Commands sflow enable (Interface) Enable sFlow on Interfaces. sflow enable (Interface) s z S6000 Enable sFlow on Interfaces. Syntax sflow enable To disable sFlow, use the no sflow enable command. Defaults sFlow is disabled by default on all interfaces sFlow | 867