Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 435
portmode hybrid, Port 0, Link Status between, Port 1 and Port 2
View all Dell S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 435 highlights
You can display master/slave settings with the show interfaces command. Figure 20-19. Display Auto-negotiation Master/Slave Setting (partial) FTOS#show interfaces configured GigabitEthernet 13/18 is up, line protocol is up Hardware is FTOSEth, address is 00:01:e8:05:f7:fc Current address is 00:01:e8:05:f7:fc Interface index is 474791997 Internet address is 1.1.1.1/24 MTU 1554 bytes, IP MTU 1500 bytes LineSpeed 1000 Mbit, Mode full duplex, Master ARP type: ARPA, ARP Timeout 04:00:00 Last clearing of "show interfaces" counters 00:12:42 Queueing strategy: fifo Input Statistics: ... Both sides of the link must have auto-negotiation enabled or disabled for the link to come up. The following table details the possible speed and auto-negotiation combinations for a line between two 10/100/1000 Base-T Ethernet interfaces. Table 20-4. Auto-negotiation and Link Speed Combinations Port 0 Port 1 Link Status between Port 1 and Port 2 auto-negotiation enabled* speed 1000 or auto auto-negotiation enabled* speed 1000 or auto Up at 1000 Mb/s auto-negotiation enabled speed 100 auto-negotiation enabled speed 100 Up at 100 Mb/s auto-negotiation disabled speed 100 auto-negotiation disabled speed 100 Up at 100 Mb/s auto-negotiation disabled speed 100 auto-negotiation enabled speed 100 Down auto-negotiation enabled* speed 1000 or auto auto-negotiation disabled speed 100 Down * You cannot disable auto-negotiation when the speed is set to 1000 or auto. portmode hybrid s z S6000 Set a physical port or port-channel to accept both tagged and untagged frames. A port configured this way is identified as a hybrid port in report displays. Syntax portmode hybrid To return a port to accept either tagged or untagged frames (non-hybrid), use the no portmode hybrid command. Defaults non-hybrid Command Modes INTERFACE (conf-if-interface-slot/port) Interfaces | 435