Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 663

Parameters process-id vrf name Enter a number for the OSPF instance. Range: 1 to 65535 (Optional) Enter the VRF process identifier to tie the OSPF instance to the VRF. All network commands under this OSPF instance are subsequently tied to the VRF instance. Defaults Not configured. Command Modes CONFIGURATION Command History Version 9.0.2.0 Version 8.3.11.1 Version 7.8.1.0 Introduced on S6000. Introduced on Z9000 Introduced support for Multi-Process OSPF. Example Figure 29-3. Command Example: router ospf FTOS(conf)#router ospf 2 FTOS(conf-router_ospf)# Usage You must have an IP address assigned to an interface to enter the ROUTER OSPF mode and configure Information OSPF. Once the OSPF process and the VRF are tied together, the OSPF Process ID cannot be used again in the system. show config z S6000 Display the non-default values in the current OSPF configuration. Syntax show config Command Modes ROUTER OSPF Command History Version 9.0.2.0 Version 8.3.11.1 Introduced on S6000. Introduced on Z9000 Example Figure 29-4. Command Example: show config FTOS(conf-router_ospf)#show config ! router ospf 3 passive-interface FastEthernet 0/1 FTOS(conf-router_ospf)# show ip ospf z S6000 Display information on the OSPF process configured on the switch. Syntax show ip ospf process-id [vrf vrf name] Open Shortest Path First (OSPFv2) | 663