Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 57

The password configured by the ip ftp password command is used when you use the ftp: parameter in the copy command. Related Commands copy ip ftp username Copy files. Set the user name for FTP sessions. ip ftp source-interface s z S6000 Specify an interface's IP address as the source IP address for FTP connections. Syntax ip ftp source-interface interface To delete an interface, use the no ip ftp source-interface interface command. Parameters interface Enter the following keywords and slot/port or number information: • For an 100/1000 Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For Loopback interfaces, enter the keyword loopback followed by a number from zero (0) to 16383. • For a Port Channel interface, enter the keyword port-channel followed by a number: S-Series: 1-128 • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a VLAN interface, enter the keyword vlan followed by a number from 1 to 4094. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/port information. Defaults The IP address on the system that is closest to the Telnet address is used in the outgoing packets. Command Modes CONFIGURATION Command History Version 9.0.2.0 Version 8.3.11.1 Version 7.6.1.0 Version 8.2.1.0 Introduced on S6000. Introduced on the Z9000. Introduced on S-Series. Increased number of VLANs on ExaScale to 4094 (was 2094) Related Commands copy Copy files from and to the switch. ip ftp username s z S6000 Assign a user name for outgoing FTP connection requests. Control and Monitoring | 57