Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 482

www.dell.com | support.dell.com ip host z S6000 Assign a name and IP address to be used by the host-to-IP address mapping table. Syntax ip host name ip-address To remove an IP host, use the no ip host name [ip-address] command. Parameters name ip-address Enter a text string to associate with one IP address. Enter an IP address, in dotted decimal format, to be mapped to the name. Defaults Not configured. Command Modes CONFIGURATION Command History Version 9.0.2.0 Version 8.3.11.1 Introduced on the S6000. Introduced on Z9000 ip max-frag-count z S6000 Set the maximum number of fragments allowed in one packet for packet re-assembly. Syntax ip max-frag-count count To place no limit on the number of fragments allowed, enter no ip max-frag-count. Parameters count Enter a number for the number of fragments allowed for re-assembly. Range: 2 to 256 Defaults No limit is set on number of fragments allowed. Command Modes CONFIGURATION Command History Version 9.0.2.0 Version 8.3.11.1 Introduced on the S6000. Introduced on Z9000 Usage Information To avoid Denial of Service (DOS) attacks, keep the number of fragments allowed for re-assembly low. ip name-server z S6000 Enter up to 6 IP addresses of name servers. The order you enter the addresses determines the order of their use. Syntax ip name-server ip-address [ip-address2...ip-address6] To remove a name server, use the no ip name-server ip-address command. 482 | IPv4 Routing