Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 510

www.dell.com | support.dell.com Defaults Without a Port Channel specified, the command clears all Port Channel counters. Command Modes EXEC EXEC Privilege Command History Version 9.0.2.0 Version 8.3.11.1 Version 8.3.7.0 Introduced on the S6000. Introduced on Z9000 Introduced on the S4810. Related Commands show lacp Display the lacp configuration debug lacp z S6000 Debug LACP (configuration, events etc.) Syntax debug lacp [config | events | pdu [in | out | [interface [in | out]]]] To disable LACP debugging, use the no debug lacp [config | events | pdu [in | out | [interface [in | out]]]] command. Parameters config events pdu in | out interface in | out (OPTIONAL) Enter the keyword config to debug the LACP configuration. (OPTIONAL) Enter the keyword events to debug LACP event information. (OPTIONAL) Enter the keyword pdu to debug LACP Protocol Data Unit information. Optionally, enter an in or out parameter to: • Receive enter in • Transmit enter out (OPTIONAL) Enter the following keywords and slot/port or number information: • For a 100/1000 Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Ten Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/port information. Optionally, enter an in or out parameter: • Receive enter in • Transmit enter out Defaults This command has no default values or behavior Command Modes EXEC EXEC Privilege 510 | Link Aggregation Control Protocol (LACP)