Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 385
member-vlan
View all Dell S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 385 highlights
Defaults No default values or behavior Command Modes CONFIGURATION (conf-frrp) Command History Version 9.0.2.0 Version 8.3.11.1 Version 8.2.1.0 Introduced on then S6000. Introduced on the Z9000. Introduced on the S-Series Usage Information This command causes the Ring Manager to take ownership of these two ports after the configuration is validated by the IFM. Ownership is relinquished for a port only when the interface does not play a part in any control VLAN, that is, the interface does not belong to any ring. Related Commands show frrp Display the Resilient Ring Protocol configuration information member-vlan s z S6000 Specify the member VLAN identification numbers. Syntax member-vlan {vlan-range} To return to the default, use the no member-vlan [vlan-range] command. Parameters vlan-range Enter the member VLANs using comma separated VLAN IDs, a range of VLAN IDs, a single VLAN ID, or a combination. For example: Comma separated: 3, 4, 6 Range: 5-10 Combination: 3, 4, 5-10, 8 Defaults No default values or behavior Command Modes CONFIGURATION (conf-frrp) Command History Version 9.0.2.0 Version 8.3.11.1 Version 8.2.1.0 Introduced on then S6000. Introduced on the Z9000. Introduced on the S-Series mode s z S6000 Set the Master or Transit mode of the ring. Syntax mode {master | transit} To reset the mode, use the no mode {master | transit} command. Parameters master transit Enter the keyword master to set the Ring node to Master mode. Enter the keyword transit to set the Ring node to Transit mode. Defaults Mode None Force10 Resilient Ring Protocol (FRRP) | 385