Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 156
cam-acl, cam-acl-egress
View all Dell S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 156 highlights
www.dell.com | support.dell.com • test cam-usage cam-acl s S6000 Allocate space for IPv6 ACLs. Syntax cam-acl {default | l2acl 1-10 ipv4acl 1-10 ipv6acl 0-10 ipv4qos 1-10 l2qos 1-10} Parameters default l2acl 1-10 ipv4acl 1-10 ipv6acl 0-10 ipv4qos 1-10 l2qos 1-10 Use the default CAM profile settings, and set the CAM as follows. L3 ACL (ipv4acl): 6 L2 ACL(l2acl): 5 IPv6 L3 ACL (ipv6acl): 0 L3 QoS (ipv4qos): 1 L2 QoS (l2qos): 1 Allocate space to support IPv6 ACLs. You must enter all of the profiles and a range. Enter the CAM profile name followed by the amount to be allotted. The total space allocated must equal 13. The ipv6acl range must be a factor of 2. Command Modes CONFIGURATION Command History Version 9.0.2.0 Version 8.3.7.0 Introduced on the S6000. Introduced on the S4810. Usage You must save the new CAM settings to the startup-config (write-mem or copy run start) then reload Information the system for the new settings to take effect. The total amount of space allowed is 16 FP Blocks. System flow requires 3 blocks and these cannot be reallocated. When configuring space for IPv6 ACLs, the total number of Blocks must equal 13. Ranges for the CAM profiles are 1-10, except for the ipv6acl profile which is 0-10. The ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10). cam-acl-egress s S6000 Allocate space for IPv6 egress ACLs. Syntax cam-acl-egress {default | l2acl 1-4 ipv4acl 1-4 ipv6acl 0-4} 156 | Access Control Lists (ACL)