Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 113
Common IP ACL Commands
View all Dell S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 113 highlights
Example Figure 6-1. Command Example: remark FTOS(config-std-nacl)#remark 10 Deny rest of the traffic FTOS(config-std-nacl)#remark 5 Permit traffic from XYZ Inc. FTOS(config-std-nacl)#show config ! ip access-list standard test remark 5 Permit traffic from XYZ Inc. seq 5 permit 1.1.1.0/24 remark 10 Deny rest of the traffic seq 10 Deny any FTOS(config-std-nacl)# Related Commands show config Display the current ACL configuration. show config s z S6000 Display the current ACL configuration. Syntax show config Command Modes CONFIGURATION-STANDARD-ACCESS-LIST CONFIGURATION-EXTENDED-ACCESS-LIST CONFIGURATION-MAC ACCESS LIST-STANDARD CONFIGURATION-MAC ACCESS LIST-EXTENDED Command History Version 9.0.2.0 Version 8.3.11.1 Version 7.6.1.0 Version 6.2.1.1 Introduced on S6000. Introduced on the Z9000. Introduced on S-Series. Introduced Example Figure 6-2. Command Example: show config FTOS(config-ext-nacl)#show conf ! ip access-list extended patches FTOS(config-ext-nacl)# Common IP ACL Commands The following commands are available within both IP ACL modes (Standard and Extended) and do not have mode-specific options. When an access-list (ACL) is created without any rule and then applied to an interface, ACL behavior reflects an implicit permit. s (non-S4810) platforms support Ingress IP ACLs only. The S6000 and z support both Ingress and Egress IP ACLs. Access Control Lists (ACL) | 113