Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 860
debug protocol-tunnel, protocol-tunnel
View all Dell S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 860 highlights
www.dell.com | support.dell.com debug protocol-tunnel z S6000 Enable debugging to ensure incoming packets are received and rewritten to a new MAC address. Syntax debug protocol-tunnel interface {in | out | both} [vlan vlan-id] [count value] To disable debugging, use the no debug protocol-tunnel interface {in | out | both} [vlan vlan-id] [count value] command. Parameters interface in | out | both vlan vlan-id count value Enter one of the following interfaces and slot/port information: • For a Fast Ethernet interface, enter the keyword FastEthernet followed by the slot/port information. • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For Port Channel interface types, enter the keyword port-channel followed by a number from 1 to 32 for EtherScale, 1 to 255 for TeraScale and ExaScale. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/port information. Enter the keyword in, out, or both to debug incoming interfaces, outgoing interfaces, or both incoming and outgoing interfaces. Enter the keyword vlan followed by the VLAN ID. Range: 1 to 4094 Enter the keyword count followed by the number of debug outputs. Range: 1 to 100 Defaults Debug Disabled Command Modes EXEC Privilege Command History Version 9.0.2.0 Version 8.3.11.1 Version 7.4.1.0 Introduced on the S6000. Introduced on Z9000 Introduced protocol-tunnel z S6000 Enable protocol tunneling per VLAN-Stack VLAN. Syntax protocol-tunnel stp To disable protocol tunneling, use the no protocol-tunnel stp command. Parameters stp Enter the keyword stp to enable protocol tunneling on a spanning tree, including STP, MSTP, RSTP, and PVST. Defaults No default values or behavior Command Modes CONF-IF-VLAN 860 | Service Provider Bridging