Dell S6000 FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 479

ip domain-list z S6000 Configure names to complete unqualified host names. Syntax ip domain-list name To remove the name, use the no ip domain-list name command. Parameters name Enter a domain name to be used to complete unqualified names (that is, incomplete domain names that cannot be resolved). Defaults Disabled. Command Modes CONFIGURATION Command History Version 9.0.2.0 Version 8.3.11.1 Introduced on the S6000. Introduced on Z9000 Usage Information Configure the ip domain-list command up to 6 times to configure a list of possible domain names. If both the ip domain-name and ip domain-list commands are configured, the software will try to resolve the name using the ip domain-name command. If the name is not resolved, the software goes through the list of names configured with the ip domain-list command to find a match. Use the following steps to enable dynamic resolution of hosts: • specify a domain name server with the ip name-server command. • enable DNS with the ip domain-lookup command. To view current bindings, use the show hosts command. To view DNS related configuration, use the show running-config resolve command. Related Commands ip domain-name Specify a DNS server. ip domain-lookup z S6000 Enable dynamic host-name to address resolution (that is, DNS). Syntax ip domain-lookup To disable DNS lookup, use the no ip domain-lookup. Defaults Disabled. Command Mode CONFIGURATION Command History Version 9.0.2.0 Version 8.3.11.1 Introduced on the S6000. Introduced on Z9000 Usage Information To fully enable DNS, also specify one or more domain name servers with the ip name-server command. IPv4 Routing | 479